Siemens M55 - Manual (Page 11)

Getting started
10
M55 Barracuda english, A31008-H6300-A1-1-7619 (30. April 2003, 10:39)
©
Siem
ens AG 2001
, I
:\Mob
il\L55\M
55_Ba
rra
cuda\en\mit_
LG\f
ug\M55
_Startup.fm
Charge battery
The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone, plug
power supply unit into a mains
power socket and charge for at
least two hours.
Display when charging is in progress
h
During charging.
Charging time
An empty battery is fully charged af-
ter about 2 hours. Charging is only
possible within a temperature range
of +5 °C to +40 °C. If the tempera-
ture rises/falls 5 °C above/below this,
the charge symbol flashes a warn-
ing. The mains voltage specified on
the power supply unit must not be
exceeded.
Charge symbol not visible
If the battery has been discharged
fully the charge icon is not visible
when the charger is plugged in. It
will appear after up to two hours. In
this case the battery is fully charged
after 3–4 hours.
Only use the charger provided!
Display while in service
Charge level display during opera-
tion (empty-full):
a d g
A beep sounds when the battery is
nearly empty. The battery level is on-
ly shown correctly during an unbro-
ken charging/discharging cycle. You
should therefore not remove the bat-
tery unnecessarily and where possible
not finish the charging process early .
pq rs
tu v
w xy z
jkl
ab
c
gh i
m
4
7
8
5
2
6
9
0
Additional information
The charger heats up when used for long
periods. This is normal and not dangerous.
Operating time.................................p. 112
Outside your home network ............p. 112
Note
Your phone's display is delivered with a protective film.
Remove this film before getting started.
Electrostatic charging can in rare cases lead to discolouring at the edge of the display. This
will, however, disappear of its own accord after 10 minutes at the most.