Sagem myX2-2m EN - Manual (Page 16)

16 Activating your phone
Charging the battery
Your phone is powered by a rechargeable battery. A new battery must be
charged for at least 4 hours before being used for the first time. It reaches its
optimum capacity after a few cycles of use.
When your battery has been discharged, the phone displays the state (empty
battery icon flashes). In this case recharge your battery for at least 15 minutes
before making any more calls so as to avoid being cut off mid-call.
To recharge the battery
Connect the charger to a mains socket.
Plug the end of the cable into the connector at the base of the phone.
The phone starts to charge up. Charging stops by itself. Disconnect the cable.
It is possible that the battery may heat up slightly during charging; this
phenomenon is normal.
WARNING
There is danger of explosion if the battery is replaced incorrectly or if it is exposed to fire.
Do not short circuit it.
The battery does not have any part that you can change.
Do not try to open the battery casing.
Use only the appropriate chargers and batteries shown in the manufacturer's catalogue.
Used batteries must be disposed of in the appropriate places.
It is advisable to remove the battery if your phone is not used for extended periods.
251959374_myX2-2_lu_en.book Page 16 Mercredi, 30. mars 2005 11:48 11