SEAL 44/62 - Manual (Page 32)

30 Troubleshooting
8 TROUBLESHOOTING
List of common problems and solutions that the user can correct:
Problem cause solution
The power LED does not
come on, when the machine
is switched on. there is no power check if the power cable is
plugged into the mains wall
outlet.
check the fuse located on the
rear side.
LED power is flashing the voltage from the
supplier is too low Machine voltage 115V:
the incoming voltage must be
between 90-130V AC.
Machine voltage 230V:
the incoming voltage must be
between 200-250V AC.
LED Forward and reverse
are flashing Drive-motor is in
overload the machine is in overload
restart the machine
For technical assistance, please contact your technical service representative (see front
cover)