Sony Ericsson M3000 User Manual

Page 2

Plantronics Ltd - Released

T68 M3000 pair rev002

July 2003

Making and Accepting Calls

To accept an in-coming call via the M3000 Headset

1. An in-coming call will cause both the phone and the headset to ring.

Note that there may be a delay of a few seconds between the phone

ringing and the headset starting to ring.

2. When you hear the ringing tone in the M3000 headset, press the “Call

Control” button to answer the call.

If you press the “Call Control” button before the headset starts to ring the

call may not be answered and an error tone will sound in the headset.

Once you hear this tone you can then press the “Call Control” button to

pick up the call.

To end a call via the M3000 Headset

The call can be ended either by pressing the “Call End / No” key on the

T68 or by pressing the “Call Control” button on the M3000.

To place a call using the keypad:

1. Dial the number as normal and press the “Call” key on the T68. The

audio will automatically be transferred to the headset.

To place a call using Voice Dialing with the M3000 Headset:

NB: Before using the M3000 for voice dialling, ensure that you have

followed the instructions in the Sony Ericsson T68 User Guide for voice

dialling, and that you have recorded the names of the contacts you wish to

call via voice dialling. Place a test call from the T68 using voice dialling to

ensure that it is working before using the M3000 headset.

1. Press and hold the “Call Control” button on the M3000 until you hear a

beep in the headset. After a moment you will hear another beep in the

headset as a prompt for voice dialling and the phone display will show

“After the tone, say a name or command”

2. State the name of the contact you wish to dial and the call will be

placed.