Sangean Sangean HDT-1 User Manual

Page 19

Troubleshooting

Issue

Power Won’t Turn On

Remote Doesn’t Work

I don’t hear any audio

I only hear audio in one speaker

I only hear static

Poor audio quality

Possible Solutions

Check AC power cord connection

Check circuit breakers/fuses

Call Sangean Service Department at 888-SANGEAN

Remove plastic piece located at bottom of remote

Replace battery

Check the area of the IR sensor and ensure there are no

obstructions and the area surrounding it is clean by using a

glass or all purpose cleaner

Call Sangean Service Department at 888-SANGEAN

Check “Power won’t turn on”

Check to make sure audio cables are properly connected.

Make sure Left is Left, and Right is Right.If using optical,

make sure cable is not bent or kinked.

Check to make sure power is connected and retry

Make sure to set your AV Receiver to corresponding inputs

used during installation

Check speakers to make sure that they are all properly

connected

Check all antennas to ensure proper connection

Check to see that you are on a frequency that is broadcasting

in your area

Call station engineer, or try another station

Check to make sure you are using the proper cables for the

inputs you chose.

Check to verify that all connections are to same format (RCA is

to RCA, Coaxial is to Coaxial, Antenna to Antenna input, etc.)

Possible Causes

AC Power Cable is not properly connected

AC Outlet power not turned on

Defective/Malfunctioning Unit

Remote Battery Not Activated

Battery is Dead

IR Sensor Obstructed

IR Sensor Malfunctioning

Remote is Defective

Power is not on

Audio cables are not properly connected

AV Receiver is not powered on

AV Receiver is not set to proper input

Speakers improperly connected

Antenna not connected properly

Tuner not tuned to a station

Station is temporarily not broadcasting

Bad/Improper Connections

20070425_HDT-1&HDT-1X_381R20S-A.p65

2007/4/30, ¤U¤И 01:44