Sangean Sangean HDT-1 - Manual (Page 17)

16
Advanced Information
Long press INFO button for 2 seconds to enter Advanced Information.
Press and release INFO button will cycle through information of RESET,
LCD Contrast Adjust, Backlight Brightness Control, (For HDT-1X:
Stereo/Mono Mode, Analog Mode, Split Audio Mode), Bit Error Rate,
The carrier to noise ratio, FUSE Bit Check , Transmission Mode,
Station ID and Software version.
a. RESET –
in RESET mode, press PRESET button to RESET the tuner.
The tuner setting will be reset to its initialized factory setting.
b. LCD Contrast –
pressing TUNING UP or DOWN button to adjust LCD contrast.
c. Back Light Setting –
pressing TUNING UP or DOWN button to adjust Back Light.
(for HDT-1X only)
d. Stereo/Mono Mode –
pressing TUNING UP or DOWN button to adjust Stereo/mono.
(only for HDT-1X )
e. Analog Mode –
pressing TUNING UP or DOWN button to turn on/off HD.
(for HDT-1X only)
f. Split Audio Mode –
pressing TUNING UP or DOWN button to split audio on/off.
(for HDT-1X only)
g. Bit Error Rate
h. The carrier to noise ratio
i. Fuse Bit Check
j. Transmission Mode ,
k. Station ID and HDT-1/HDT-1X
l. Software version are for factory and after sales service reference.
20070425_HDT-1&HDT-1X_381R20S-A.p65 2007/4/30, ¤U¤И 01:44 19