Sangean Sangean HDT-1 - Manual (Page 16)

15
Recall preset stations
To recall preset stations, select required band by pressing BAND
selection button. Press PRESET button to enter PRESET recall mode.
Display will show “GO TO PRESET”. Then followed by using one of the
following methods to recall the stations.
1. Press and release the number station you like to recall.
2. Press TUNING UP or DOWN button to select required preset station.
Note:
If the preset station you like to recall has no preset station, display will
show EMPTY.
Exchange preset stations position
You may use the Presets exchange function to change the position of
the preset stations.
E.g. preset 1: 93.10 MHz and preset 2: 100.70 MHz
If you like to exchange preset 1 to be preset 2. First to recall Preset 1
station, then long press number button 2 for more than 2 seconds until
display indicating the new preset has been stored.
For HDT-1 only:
Note: If memory is full during preset station exchange, display will
appear FULL, then press number button 2 for more than 5 seconds until
display indicating the new preset has been stored.
20070425_HDT-1&HDT-1X_381R20S-A.p65 2007/4/30, ¤U¤И 01:44 18