Sanyo EM-Z2100GS - Manual (Page 9)

9
INSTALLATION
Remove all packing material and accessories. Examine the oven for any
damage such as dents or broken door. Do not install if oven is damaged.
NOTE: This unit is not designed for 50 Hz or any circuit other than a 120-volt/
60-Hz AC circuit. This oven is designed for countertop installation.
Countertop Installation
1. Select a level surface that
provides enough open space for
the intake and/or outlet vents.
Minimum clearances required
between the oven and any adjacent
walls are shown above.
• Leave a minimum clearance of
8 inches above the oven.
• Do not remove the legs from
the bottom of the oven.
• Blocking the intake and/or outlet
openings can damage the oven.
• Place the oven as far away
from radios and TV’s as possible.
Operation of microwave oven
may cause interference to your
radio or TV.
• If the cabinet is covered with a
protective film, remove the film.
2. Plug your oven into a standard
120-volt / 60-Hz household outlet.
Be sure the electrical circuit is
at least 15 amperes and that
your microwave oven is the
only appliance on the circuit.
WARNING: Do not install oven
over a range cooktop or other
heat-producing appliance. If
installed near or over a heat source,
the oven could be damaged and the
warranty would be void.
SET UP
25941_EM_Z2100GS manual.qxd 7/7/05 8:32 AM Page 9