Sony SNC-xx User Manual
Page 13
1
3
1
2
Setting the IP Address
of the Camera
7
When installation is completed, select [All Programs],
[IP Setup Program], and then click [IP Setup Program]
from the [Start] menu.
If the message “User Account Control – An unidentified program wants access to your computer”
appears, click [Allow].
The IP Setup Program starts, and the “Network” tab appears.
The IP Setup Program detects the camera connected on the network, and lists it.
Information on the cameras detected is displayed in the list.
In this Setup Guide, the MAC address is described as “XX-XX-XX-XX-
XX and the model name as “SNC-xx.” In the list, the value of the actual
MAC address and the actual model name are displayed.
If the camera information does not appear in the list, the following causes may be considered.
You have not set the IP address correctly on your computer.
Go back to
Confirming the Settings of the Computer
1
on page 4, and check whether or not the IP address is set correctly.
You have not connected the camera and the computer on the same network.
Check whether or not they are connected correctly, referring to “Before Using Your Camera For the First Time” on page 2.
You have not turned the camera on.
Check whether or not you have turned the camera on.
The security level that is selected for virus scans, a personal firewall, etc., is set to the high level.
Reset it to the standard level. For detailed information on how to reset it, refer to the manual for the security software first. If the
problem persists, contact the maker of the security software.