Sony SU-FL61 - Manual (Page 17)

7
(GB)
Install the TV
1
Prepare for the installation of the
TV.
Detach the Table-Top Stand (if attached) and remove
the two screws from the rear of the TV. For details,
refer to the leaflet supplied with the TV.
2
Attach the four hooks on the rear
of the TV.
Place the TV with its screen facing down on a stable
cloth-covered work surface.
Attach the four hooks with the four hook screws.
• When using an electric screwdriver, set the torque setting
to approximately 2 N·m {20 Kgf·cm}.
• Be sure not to use any screws other than the supplied ones
(+PSW5 × L16) when attaching the hooks.
Soft cloth
Align the hook with the circle on the
rear of the TV.
Hook screw
Hook
Notes
3
Attach the TV to the TV Stand.
1 Hold the TV as illustrated below, and insert the four
hooks on the rear of the TV into the top portion of
the holes of the center pillar. Check that all four
hooks are firmly secured in the four holes.
Be careful not to topple the TV Stand when attaching the TV
to the TV Stand.
2 Push the TV straight down to securely seat the
hooks into the TV Stand as shown.
• Confirm the hooks are firmly seated into the bottom of the
holes, then check that the TV hangs parallel level.
• Be careful not to move the TV Stand while attaching the
TV.
Note
Notes