Sanyo PDG-DET100L - Manual (Page 53)

53
Setting
Advanced
color matching . . . . . Set to ‘On‘ to activate the ‘Advanced color
matching’. When it is set to ‘Off‘, all items
except for ’Test pattern’ are displayed in
grayout and cannot be adjusted.
Measured . . . . . . . . When using the color wheel set optimized
for high brightness, the chromatic coordinate
(X,Y) and the brightness (L) of Red, Green,
Blue, Half white, and White are displayed
(Fig.1). When using the color wheel set
optimized for rich color reproduction, the
chromatic coordinate (X,Y) and the brightness
(L) of Red, Green, Blue, and White are
displayed (Fig.2).
Information: Select ‘Information’ and press the SELECT
button to display the information dialog box
(Fig.3). Measured information display can be
used to confirm the current setup condition of
the Image select menu and the color wheels.
Target . . . . . . . . . . . Adjust the chromatic coordinate (X,Y) and
the gain value (g) of Red, Green, Blue, Cyan,
Magenta, Yellow, and White. Use the Point
ed7 8 buttons to move the red frame
pointer to an item of which you want to adjust
the value and then press the SELECT button.
Use the Point ed buttons to adjust the value.
To move to the next digit, use the Point 7 8
buttons. Press the SELECT button to set the
value.
Auto test pattern . . . Select ‘On‘ to display a suitable pattern when
setting items.
Factory default . . . . Select ‘Factory default’ and press the SELECT
button. Then ‘Return to factory default of
Color matching?‘ message appears. To reset
the selected Measured value and Target
value, select [Yes]. Then, the confirmation box
appears. Press the SELECT button at [Yes]
again.
Reset . . . . . . . . . . . . Select ‘Reset’ and press the SELECT button.
Then the confirmation message appears.
Press the SELECT button at [Yes] to reset to
the previously stored values.
Store . . . . . . . . . . . . Select ‘Store’ and press the SELECT button.
Then the confirmation box appears. To store
adjusted data, select [Yes].
Test pattern . . . . . . . When using the color wheel set optimized for
high brightness, use the Point ed buttons to
select from (Measured) Red/Green/Blue/Half
white/White/(Target) Red/Green/Blue/ Cyan/
Magenta/Yellow/White.
When using the color wheel set optimized
for rich color reproduction, use the Point ed
buttons to select from (Measured) Red/Green/
Blue/White/(Target) Red/Green/Blue/Cyan/
Magenta/Yellow/White.
Quit . . . . . . . . . . . . .Exit the Color matching menu.
DynamicBlack
DynamicBlack TM improves the black level of the projector. Black
level is the darkest part of a picture and varies between viewing
devices and environments. Set DynamicBlack Off/Low/High.
Advanced color matching
Close this
dialog box.
✔ Note:
• In the Measured information dialog box, ‘Standard’
indicates all the Image select menus other than
‘Dynamic’.
✔ Note:
• DynamicBlack is fixed to ‘Off’ when ‘DICOM‘ is
selected in the Image level selection (pp.39, 43).
Fig .1 For high brightness color wheel
Fig .2 For rich color reproduction color wheel
Fig .3 Measured information dialog box