Connecting the power – Samsung SP-A400B User Manual
Page 21

4.
Click on [Monitor] tab and set the
referring to
the Supported
Resolution/Size Modes table
.
Set up both the vertical and horizontal frequency instead of
5.
Click the [OK] button to close the window, and click the
[OK] button of the
window.
The computer may restart automatically.
6.
Shut down the PC and connect to the projector.
Process might vary depending on your type of computer or Windows versions.
(For example, [Properties] appears instead of [Properties (R)] as shown in 1.)
This unit appliance supports up to 24 bits per pixel in Color quality when it is used as a PC monitor.
Projected images may differ from the monitor depending on monitor manufacture or Windows versions.
When connecting the projector to a PC, check that PC setup complies to display settings supported by this
projector. If not, there may be signal problems.
|
Basic Settings
|
Connecting the Power
|
Connecting to video equipment
|
1. Rear of Projector
Plug the power cord into the power terminal on the rear side of the projector.
When used outside of the U.S., HAR cord with fittings of an approved agency may be used.