SoundCraft D-Mix 500 - Manual (Page 12)

General Precautions
Avoid storing or using the mixing console in conditions of excessive heat or cold,or in
positions where it is likely to be subject to vibration, dust or moisture. Do not use any
liquids to clean the fascia of the unit: a soft dry brush is ideal. Solvents may cause
damage to paint or plastic parts.
Avoid using the console close to strong sources of electromagnetic radiation (e.g video
monitors, high power electric cabling): this may cause degradation of the audio quality
due to induced voltages in connecting leads and chassis. For the same reason, always
site the power supply away from the unit.
Caution!
In all cases, refer servicing to qualified personnel.
Handling and Transport
The console is supplied in a strong carton. If it is necessary to move it any distance after
installation it is recommended that this packing is used to protect it. Be sure to
disconnect all cabling before moving. If the console is to be regularly moved we
recommend that it is installed in a foamlined flightcase. At all times avoid applying
excessive force to any knobs, switches or connectors.
Power Supplies & Cables
Always use the power supply and cable supplied with the mixer: the use of alternative
supplies may cause damage and voids the warranty; the extension of power cables may
result in malfunction of the mixing console.
Warning!
Always switch the power supply off before connecting or
disconnecting the mixer power cable, removing or
installing the Cross Fader, and servicing. In the event of
an electrical storm, or large mains voltage fluctuations,
immediately unplug from the mains.
Precautions and Safety Instructions
2.4 D-MIX500 Installation