Sirius Satellite Radio SIRIUS InV2 - Manual (Page 23)

[
Installation
] 23
Follow these detailed cable installation instructions:
Use a plastic putty knife or similar tool to lift the rubber molding around the wind-
shield and tuck the antenna cable underneath it.
Continue tucking the cable underneath the windshield molding around the wind-
shield to the lowest corner.
At the lowest corner of the windshield, route the cable out of the windshield mold-
ing and into the rubber weather stripping around the door opening. Lift the weather
stripping from the opening and tuck the cable inside it, then replace the weather
stripping. Run the cable inside of the weather stripping to the bottom of the door
opening.
Pull the cable out of the weather stripping at the bottom of the door opening and
route it under the carpet toward the dashboard. Coil any excess cable in a hidden
location, such as under the carpet, keeping it away from any vehicle pedals or
controls. Secure the excess cable with wire ties.
Bring the end of the cable out at the SIRIUS Vehicle Dock location. Leave yourself
enough cable so you can easily connect it to the antenna connector on the Vehicle
Dock. 1.
2.
3.
4.
5.