Siemens WD7005 - Manual (Page 50)

48
Electrical connection
When heating, the maximum current of the washer-
dryer is 10A, so please make suer that the power
supply system (voltage, current and cable) is appli-
cable to the load of theapplied appliance.
The machine must only be connect to an alternat-
ing current supply via a correctly installed earthed
socket.
The voltage indicated on the rating plate at the
back of the machine must match the mains voltage
at the installation location.
Connected load and required fuse or line protect-
ing cut-out are indicated on the rating plate.
It must be ensured that the plug and socket match,
that the conductor cross-section is sufficient and
that the earthing system has been installed in
compliance with regulations.
Multiple plug connectors and extension cables
must not be used.
Do not connect the machine to electrical outlets
while your hands are wet or damp.
To remove the plug from the socket, grasp the
plug firmly and pull it out. Do not pull at the cable.
If the supply cord is damaged, it will be replaced
by a special cord or a assembly available from
the manufacturer or its service agent.
In the event that an earth-leakage circuit breaker is
to be used, only use types marked with the follow-
ing symbol: . Only this symbol can guarantee
compliance with all current regulations.