Siemens WD7005 - Manual (Page 37)

35
Trouble Shooting Minor Faults
Risk of electric shock
Repairs must only be carried out by our Customer
Service or an authorized technician. If repairs are
needed, and assuming that you cannot eliminate
the fault yourself with the aid the following table:
Turn the programme selector to Off .
Disconnect the washer-fryer from the mains.
Turn off the water tap.
Call Customer Service.
, , ,,
A signal emitted
in display field
E02
E01
Check whether laundry is trap-
ped in door;
Close the washer-dryer door.
Turn the tap on.
Eliminate cause.
Clean filter, see 33.
Eliminate cause.
Possible cause Action
Door not colosed properly.
Tap not turned on.
Inlet hose kinked or pinched.
Filter blocked in water inlet
hose.
Water pressure too low.
E04 Lose debris is blocking the
pump;
Drainage pipe blocked Clean the pump, see page 32;
Clean the drainage pipe.