Siemens WD7005 - Manual (Page 38)

36
Fault Possible cause Action
Detergent residue in the
detergent dispenser.
The washer-dryer door
cannot be opened. Select Draining or Spinning .
Clean and dry the detergent
dispenser(refer to Page 31)
Use the dispensing aid for liquid
detergent.
There is water in drum.
Safety function is active. Wait for 2 minutes.
Detergent was damp or
lumpy.
The gasket is crimped. This may appears after
installing the transport bolts. Remove the transport bolts, operate
the machine for a period of time, the
gasket will return to the original shape.
The belt gets off the pulley. Too much laundry is in the
drum or the laundry is put in
badly, and close the window
with excessive force. Put in the laundry well and according
to the maximum load specifiction.
Control lights do not
come on.
Close the loading door(a click sh-
ould be heard).
The programme
does not start.
Plug is loose or not inserted.
An interrupted program will be re-
sumed when power retures. If you
wish to unload the laundry, proce-
ed as in Cleaning the drain pump ,
Page 32.
A fuse has triggered. Switch on/replace the fuse.
Call Customer Service if this fault
is repeated.
Power failure.
Loading door not closed. Check whether laundry is trapped
in door.
Start button does not
pressed. Press the Start button.
Water cannot be seen in
drum.
Detergent in chamber I is
not wash away. Prewash function is
not selected.
Press Prewash button
This is not a fault.
The water lies below the visible part of the drum.
Motor noise
Pump noise
Not a malfunction! It is normal for noises to be heard while the
motor is running.
Not a malfunction! It is normal for noises to be heard from the
pump during the start or the final stage of draining the drum.
Vibrations when
washing and spinning
Transit bolts not removed.
The machine s feet were
not secured.
Follow the directions in the insta-
llation instructions (page 41)
Realign the machine using a spirit
level,see the installation instructions.
Leak in the drain hose.
The thread of the supply
hose is not tight. Water is flowing out from
underneath the machine. Tighten the thread.
Replace the drain hose.