Seagate Ultra 160 - Manual (Page 26)

12 Parallel SCSI Interface Product Manual, Rev. A
1.3 Physical interface characteristics
The physical interface characteristics (cables, connectors, electrical descriptions, termination requirements,
etc.) for the drives covered by this Interface Manual are found in each individual drive’s Product Manual, since
these features are not the same for all drives.
1.4 Summary of SCSI messages
Following is an alphabetical summary of the SCSI messages described in this manual. Details are given in
Section 4.
Message Name Hex Code Page number
ABORT TASK 06 105
CLEAR QUEUE 0E 106
DISCONNECT 04 87
EXTENDED MESSAGE 01 84
IDENTIFY 80-FF 87
IGNORE WIDE RESIDUE 23 88
INITIATE RECOVERY 0F Not described in this manual
INITIATOR DETECTED ERROR 05 89
MESSAGE PARITY ERROR 09 89
MESSAGE REJECT 07 89
MODIFY DATA POINTER 01, 05, 00 89 (extended message)
NO OPERATION 08 91
PARALLEL PROTOCOL REQUEST 01, 06, 04 92
QAS REQUEST 55 96
RELEASE RECOVERY 10 Not described in this manual
RESTORE POINTERS 03 96
SAVE DATA POINTERS 02 96
SYNCHRONOUS DATA TRANSFER REQUEST 01, 03, 01 97 (extended message)
TASK ATTRIBUTE MESSAGES 102
ACA (AUTO CONTINGENT
ALLEGIANCE)
24 103
HEAD OF QUEUE TAG 21 104
LINKED COMMAND COMPLETE 0A 89
ORDERED QUEUE TAG 22 104
SIMPLE QUEUE TAG 20 104
TASK COMPLETE 00 99
TASK MANAGEMENT MESSAGES 105
ABORT TASK 00 105
ABORT TASK SET 06 106
CLEAR ACA 16 106
CLEAR TASK SET 0E 106
LOGICAL UNIT RESET 17 106
TARGET RESET 0C 106
WIDE DATA TRANSFER REQUEST 01, 03 100 (extended message)