SMC Networks SMC-EZ108FDT User Manual
SMC Networks Computer Accessories
Table of contents
Document Outline
- Table of Contents
- Introduction
- Installing the Switch
- Description of Hardware
- Mounting the Switch
- Stacking Switches on a Flat Surface
- 1. Stick the self-adhesive rubber foot pads (that come with this package) on each of the 4 concav...
- 2. Place the first switch on a firm flat surface where you want to install the stack.
- 3. Repeat step 1 for each switch before stacking them. The rubber foot pads cushion the switch ag...
- Stacking Switches on a Flat Surface
- Installing a Module
- 1. Disconnect power to the switch (modules are not hot-swappable).
- 2. Remove the face plate on the appropriate slot by removing the two screws with a flat-head scre...
- 3. Before opening the package that contains the module, touch the bag to the switch casing to dis...
- 4. Remove the module from the anti-static shielded bag.
- 5. Holding the module level, gently push it all the way into the slot along the guide rails, ensu...
- 6. If you are sure the module is properly mated with the connector, tighten the retainer screws t...
- VLAN Setting:
- Connecting the Switch System
- 1. Prepare the network devices you wish to network. Make sure you have installed 10BASE-T or 100B...
- 2. Prepare straight-through shielded or unshielded twisted-pair cables with RJ-45 plugs at both e...
- 3. Connect one end of the cable to the RJ-45 port of the network interface card, and the other en...
- Notes: 1. When connecting to another compatible switch or hub, run straight-through cable between...
- 2. Make sure each twisted-pair cable does not exceed 100 meters (328 feet).
- 3. We advise using Category 5 cable for all network connections to avoid any confusion or inconve...
- Connecting to a fiber optic Port
- Powering On the Switch
- 1. Plug the power cord into the power socket on the rear of the switch, and the other end into a ...
- 2. Check the LED marked Power on the front panel to see if it is on. The unit will automatically ...
- 3. The switch performs a self-diagnostic test upon power-on. (Note that this test takes several m...
- Verifying Port Status
- Verifying System Operation
- Product Specifications
- Base Unit
- Physical Characteristics
- Switching Criteria
- Traffic Control
- Media Expansion Modules
- Fiber Uplink Module
- Base Unit
- Troubleshooting
- Diagnosing Switch Indicators
- Power and Cooling Problems
- Installation
- Port and Cable Assignments
- RJ-45 Port Description
- Module ordering information:
- EMI Certification
- FCC Class B Certification (USA)
- 1. This device may not cause harmful interference, and
- 2. This device must accept any interference received, including interference that may cause undes...
- CE Mark Declaration of Conformance
- FCC Class B Certification (USA)