Sony Ericsson D750i - Manual (Page 29)

This is the Internet version of the user's guide. © Print only for private use.
29
Calling
To answer a call using
voice commands
When the phone rings, say “Answer” and the call
is connected.
To reject a call using
voice commands
When the phone rings, say “Busy”. The call
is rejected. The caller is diverted to voicemail,
if activated, or hears a busy tone.
Editing your voice commands
You can edit all your voice commands saved in
Contacts . Select the contact you want to edit a
voice command for } More } Edit contact . Scroll to
the relevant tab and edit your voice command.
To re-record a voice command
1 } Settings } the General tab } Voice control
} Voice dialling } Edit names .
2 Select a voice command } More
} Replace voice .
3 Wait for the tone and say the command.
Tips when recording and using
voice commands
If your phone cannot detect your voice command,
one of the following might have happened:
• You spoke too softly – try speaking louder.
• You held the phone too far away – hold it as you
do during a call.
• The voice command was too short – it should
be around one second long and more than
one syllable.
• You spoke too late or too soon – speak
immediately after the tone.
• You did not record the voice command when
the handsfree was attached – for voice control
with a handsfree kit, record when the handsfree
is attached.
• You used another intonation – use the same
intonation as in the recorded voice command.