Samsung MM-X5 - Manual (Page 4)

GB
7
The power cord must be plugged into an 120V AC wall
outlet.
Plug the power cord into an AC outlet.
Press the ( ) button to switch your micro compo-
nent system on.
To take full advantage of your new micro component sys-
tem,
follow these installation instructions before connecting
the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
For ventilation purposes,maintain an open space of
approximately 6 inches (15 cm) on the sides and rear of
the system.
Make sure that you have enough room to open the com-
pact disc compartment easily.
Where to Install Your
Micro Component System
Connecting your System to the
Power Supply
2
GB
6
Inserting Remote Control Batteries
Insert or replace remote control batteries when you:
Purchase the micro component system
Find that the remote control is no longer operating cor-
rectly
When replacing the batteries, use a new set of batter-
ies and never mix alkaline and manganese batteries.
Place your thumb on the position marked on the
battery compartment cover (rear of the remote con-
trol) and pull the cover in the direction of the arrow.
Insert two AAA, LR03 or equivalent batteries, taking
care to respect the polarities:
+ on the battery against + in the battery
compartment
– on the battery against – in the battery
compartment
Replace the cover by sliding it back until it clicks into
position.
1
2
3
1
The auxiliary input can be used to take advantage of
the sound quality of your micro component system
when listening to other sources.
Examples: A television
A DVD player
A VCR
To connect to the external source, the source must
have an audio output.
Set the system to standby mode and disconnect it
and the external source from the AC outlet.
Connect the audio cable to the rear of the micro com-
ponent system.
For optimum sound quality, do not invert the right
and left channels.
Plug the system back into the AC outlet and press
( ) to switch it on.
Select the AUX source by pressing FUNCTION.
Result:
AUX is displayed.
Switch the external source on.
Example: You can watch a film on your DVD Player
and take advantage of stereo sound this
unit provides.
Connecting to an External Source
1
2
3
4
5
iPod Connection
You can listen to the audio from an iPod through the
main unit.
Audio Cable
If the external analog
component has only
one Audio Out, connect
either left or right.
iPod is registered trade mark of Apple
Computer,Inc.
When the unit is powered on and you connect an
iPod MP3 player, the unit will charge your iPod's
battery.
Set the system to standby mode and disconnect it
and the external source from the AC outlet.
Choose the appropriate iPod adapter and place into
the micro component system.Place the iPod into the
adapter and connect the iPod player to the top of the
micro component system.
Plug the system back into the AC outlet and press
( ) to switch it on.
Select the iPod source by pressing FUNCTION.
Result:
Apple is displayed.
Switch the iPod on.
1
2
3
4
5