Snapper 1602 User Manual

Page 5

into forward position and Sno-Away will travel for-
ward when the clutch is engaged. To

the

Sno-Away, disengage the clutch and pull up on

shift lever and transmission will shift into the re-
verse position. Neutral position of the shift lever is
half way between forward and reverse and thr
will be held in this position by a detent lever on the
left side of the Sno-Away frame.

The skid

shoes on

each side of

rotor hous-

ing are adjustable either up

to suit

face over which the Sno-Away is to be

For smooth surface, loosen the nuts and

shoes so that the

of the rotor housing

rides near the surface. For use over an

rough surface

the shoes for maximum lift.

When using the Sno-Away, adjust the discharge

spout so that the snow will be thrown with

wind and never into the wind. Throwing snow into
the wind will be a source of discomfort to the op-
erator.

To alter the direction of discharge,

the spout by means of the spout adjusting handle.

The distance that the snow may be thrown may be
adjusted by

the two wing nuts on the dis-

charge spout extension and raising or lowering.
extension to

the desired angle.

adjusting,

push the

snugly against the spout

bly to prevent snow from being blown backwards

against

engine and operator. Slotted holes be-

neath

wing nuts will allow this to

tightening the wing nuts to hold

thr

in the

position,

When operating

Sno-Away through

drifts of snow, depress the

and

tor housing

taking

first pass through

drift.

Then back off and lower

rotor

and go through again. After

first path through

thr drift has been

it may

only a portion of thr width of

plow

passes. Naturally,

plowing method-

will

one snowfall to another

from lo-

cation to location.

operator w-ill

which mrthods

the

results.

transporting the plow from

location to

r o t o r c l u t c h f o r

IMPORTANT

After completion of plowing operation,

allow

engine to operate in a sheltered

area for about 5 minutes to dry itself and

prevent the

ice. When pos-

sible, store the Sno-Away

a cold area

so that clinging

will not melt and

refreeze into ice.