Sony Z1010 User Manual
Page 30
This is the Internet version of the user's guide. © Print only for private use.
30
Calling
To reject a call using voice
commands
When the phone rings, say “Busy”. The call is
rejected. The caller is diverted to voicemail, if
activated, or hears a busy tone.
Editing your voice commands
You can keep all your voice commands up to date by
re-recording them or deleting the ones you do not use.
You can also edit a voice command for a phone
number in the phonebook.
Select the contact you
want to edit a voice command for, press
More
}
View & edit
, and select
.
To re-record a voice command
1
}
Settings
}
the
General
tab
}
}
Voice dialling
}
Edit names
.
2
Select a voice command, press
More
}
Replace
voice
.
3
Lift the phone to your ear, wait for the tone and
say the command.
Tips when recording and using voice
commands
If your phone cannot detect speech, one of the
following might have happened:
• You spoke too softly – try speaking louder.
• You held the phone too far away – hold it as you
do during a call.
• The voice command was too short – it should
be around one second long and more than one
syllable.
• You spoke too late or too soon – speak immediately
after the tone.
• You did not record the voice command when the
handsfree was attached – for voice control with a
handsfree kit, record when the handsfree is
attached.
• You used another intonation – use the same
intonation as you did when recording the voice
command.
Diverting calls
If you cannot answer incoming calls, you can divert
them to another number, for example, your answering
service.
You can choose between the following divert options:
•
Divert always
– divert all calls.
•
When busy
– divert calls if you are already
on the phone.
•
Not reachable
– divert calls if your phone
is turned off or if you are unreachable.
When the Restrict calls function is activated, some
Divert calls options are not available.