Using unix commands, Sun proprietary/confidential: internal use only – Sun Microsystems 6900 User Manual
Page 16
XVI
Sun StorEdge 3900 and 6900 Series 2.0 Troubleshooting Guide • March 2003
Sun Proprietary/Confidential: Internal Use Only
provides information on host device troubleshooting.
provides information on troubleshooting a Sun StorEdge Network FC
switch-8 and switch-16 switch device.
describes how to troubleshoot the Sun StorEdge T3+ array devices. Also
included in this chapter is information about the Explorer Data Collection Utility.
provides detailed information for troubleshooting the virtualization
engines.
describes how to troubleshoot using Microsoft Windows 2000. It also
explains how to launch the Sun StorEdge T3+ Array Failover Driver GUI and
interpret the multipath configurator.
provides an example of fault isolation. It begins with how to discover an
error and shows the user steps that are necessary for resolution.
provides virtualization engine references, including Service Request
Numbers (SRNs) and Simple Network Management Protocol (SNMP) Reference, an
SRN/SNMP single point-of-failure table, and port communication and service code
tables.
provides a list of
SUNWsecfg(1M)
error messages and
recommendations for corrective action.
Using UNIX Commands
This document may not contain information on basic UNIX
®
commands and
procedures such as shutting down the system, booting the system, and configuring
devices.
See one or more of the following documents for this information:
■
Solaris Handbook for Sun Peripherals
■
AnswerBook2™ online documentation for the Solaris™ operating environment
■
Other software documentation that you received with your system