beautypg.com

Sears 831.285780 User Manual

Page 5

background image

6. Make sure that all parts of the stepper are properly tightened. To protect the floor or carpet from damage,

place a mat under the stepper.

5

4. Slide the Right Handlebar (10) onto the right side of the

Upright (2). To keep the Handlebar from binding, slide both
ends of the Handlebar on at the same time.

While another person pulls back the upper end of the Foam
Handgrip (57), loosely thread two #8 x 1/2Ó Screws (25) into
the Right Handlebar and the Upright. If necessary, move the
Right Handlebar slightly to align the holes in the Right
Handlebar with the holes in the Upright. Next, pull back the
lower end of the Foam Handgrip (57) and loosely thread two
more #8 x 1/2Ó Screws (25) into the Right Handlebar and the
Upright. Tighten all four #8 x 1/2Ó Screws (25).

Attach the Left Handlebar (11) to the Upright (2) in the same
manner.

5. If there are rubber bands on the ends of the 5/8Ó x 15Ó Rod

(43), remove them. Slide a Wheel (44) onto one end of the
Rod. Attach the Wheel with an M6 x 20mm Button Screw (45)
and a 3/8Ó Flat Washer (46).

Attach a Wheel (44) to the other end of the 5/8Ó x 15Ó Rod (43)
in the same manner.

Plug the Power Cord (30) into the jack on the front of the
stepper.

10

11

57

25

25

2

4

30

44

43

46

45

5