SIIG 04-0265F - Manual (Page 10)

10
4. Click Finish and restart Windows to complete the
installation.
Windows XP /Server 2003 (64-bit)
For New Windows XP/2003 Installation
A new installation of Windows XP 64-bit/Server 2003
64-bit requires a floppy disk for the driver installation.
To make this floppy disk, copy the contents of the 64bit
folder, found on the driver CD, onto a blank floppy disk
then follow the directions below.
1.
Install the board and follow Microsoft procedures
to install Windows accordingly.
2. Restart your system when prompted by Windows
installation.
3. At the Windows Setup screen, press F6 to install the
driver.
4. Insert the floppy disk you made above. Press S then
press Enter.
5. Select Silicon Image SiI 3512... that matches your
system processor, then press Enter.
6. Press Enter to continue and follow the on-screen
instructions to complete the installation.
For Existing Windows XP/2003 Installation
1.
Install the board and boot up Windows.
2. At the Found New Hardware Wizard, select No, not
at this time, then click Next.
3. Insert the driver CD, select Install the software
automatically (Recommended), and click Next.
4. Click Finish and restart Windows to complete the
installation.