Sunbeam BVMC-ECMP1001W - Manual (Page 5)

English 9
HOW TO SELECT THE RIGHT CUP
Please make sure to select your cup according to the following chart:
BEVERAGE AMOUNT
Espresso Single ( )
Double ( )
1.25 oz
2.5 oz
Cappuccino Single ( )
Double (
)
6 oz
10 oz
Latte Single ( )
Double ( ) 12 oz
15 oz
NOTE: The total amount of the beverage can vary depending on the type of
milk used and Froth Control Knob setting.
SELECTING THE RIGHT COFFEE
THE COFFEE
The coffee should be freshly ground and dark roasted. You may want to try a
French or Italian roast ground for espresso. Pre-ground coffee will only retain
its flavor for 7 – 8 days, provided it is stored in an airtight container and in
a cool, dark area. Do not store in a refrigerator or freezer. Whole beans
are recommended to be ground just before use. Coffee beans stored in an
airtight container will keep its flavor for up to 4 weeks.
THE GRIND
This is a vital step in the espresso making process if you are grinding your
own coffee and takes practice. The coffee must be of a fine grind.
• The correct grind should look like salt.
• If the grind is too fine, the water will not flow through the coffee even
under pressure. These grinds look like powder and feel like flour when
rubbed between fingers.
• If the grind is too coarse, the water flows through the coffee too fast,
preventing a full-flavored extraction.
Be sure to use a quality grinder for uniform consistency. A conical or burr mill
grinder is recommended for a consistent and fine espresso grind.
English 8
BEFORE USING YOUR APPLIANCE
FOR THE FIRST TIME
CLEANING AND PRIMING THE UNIT PRIOR TO FIRST USE
Please refer to the “Diagram of Parts” section to familiarize yourself with the
product.
1. Please make sure the unit is off “O” by pressing the on/off “I/O” button
located on the right side of the unit. Make sure it is unplugged from the
electrical outlet.
2. Remove stickers and labels from the unit.
3. First remove and then wash the water reservoir, the milk reservoir,
the porta-filter, the 2 filters and measuring scoop in a mixture of mild
detergent and water. Rinse each thoroughly and place them back into
the unit.
4. Refer to the instructions in “Placing the Porta-Filter” section before
placing or removing the porta-filter and filter from the unit.
5. To clean/prime the internal components of unit, follow the instructions in
the “IMPORTANT - Prime the Unit” section of the manual.
IMPORTANT - PRIME THE UNIT
To prime the unit, follow these steps:
1. Fill water reservoir up to the “MAX” level.
2. Fill the milk reservoir with water up to the MAX level and slide the milk
reservoir in place. Be sure to push firmly in place.
3. Select one of the filters and place it on the porta-filter. Place the porta-
filter in the unit ensuring it is properly locked and place a cup under it.
Also, make sure the tip of the frothed milk dispensing tube is pointing
inside the cup.
4. Plug the appliance into the appropriate outlet.
5. Turn the power button on “I”.
6. The 3 control panel lights will start pulsing. Once these lights become
solid, press the espresso button “ ” and hold it for 3 seconds, then
release it. Once the pump starts, let the water flow for up to 90 seconds.
7. Press the espresso button “ ” once again to stop the process.
8. Press the cappuccino button“ ” and hold it for 3 seconds, then release
it. Once the pump starts, let the water flow for up to 90 seconds.
9. Press the cappuccino button “ ” once again to stop the process.
10. The 3 control panel lights will turn on solid indicating that the unit is
ready to be used.
Now your unit has been primed and is ready to be used.