Shindaiwa T282 TRIMMER X7502824801 - Manual (Page 11)

11
Make sure the
attachment is clear
of obstructions!
...and pull recoil
starter handle
upward
Hold
the unit
firmly...
Closed
Move the choke lever to the
CLOSED position
Slide ignition to ON
Starting the Engine
IMPORTANT!
Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and “O” for OFF
or STOP.
1. Slide the ignition switch to the “I” position.
WARNING!
Never start the engine from the operating position.
3. Set the choke lever to the CLOSED position if engine is cold.
IMPORTANT!
The primer system only pushes fuel through the carburetor. Repeatedly pressing the
primer bulb will not flood the engine with fuel.
Press primer bulb...
Primer Bulb
Return
Tube
2. Press the primer bulb until fuel can be seen flowing in the transparent return tube.
4. While holding the outer tube firmly with left hand. Use your other hand to slowly
pull the recoil starter handle until resistance is felt, then pull quickly to start the
engine.
ON
WARNING!
The attachment will operate immediately when the engine starts and could result in loss of control and possible
serious injury. Keep movable parts of the attachment away from objects that could become entangled or thrown.