SoundCraft UREI 1601S - Manual (Page 12)

12
INSPECTION AND INSTALLATION
UNPACKING AND INSPECTION
Your 1601S or 1601 was carefully packed at the factory, and the container was designed to protect the unit from rough handling.
Nevertheless, we recommend careful examination of the shipping carton and its contents for any sign of physical damage which
could have occurred in transit.
If damage is evident, do not destroy any of the packing material or the carton, and immediately notify the carrier of a possible claim
for damage. Shipping claims must be made by the consignee.
The carton should contain:
Model 1601S or 1601 Music Mixer.
Mains Cable
UREI Instruction Manual (this book).
Warranty Card (the serial number tag is on the base panel of the Mixer).
2mm Allen key
ENVIRONMENTAL CONSIDERATIONS
The 1601S/1601 Mixer will operate satisfactorily over a range of ambient temperatures from 0 C to +50C (+32F to +122F), and up
to 80% non-condensing relative humidity.
If the system is installed in an equipment rack, console or desk with high heat producing equipment (such as power amplifiers),
adequate ventilation should be provided in order to assure longest component life. Also, while circuitry susceptible to hum pick-up
is sufficiently shielded from moderate electromagnetic fields, installation should be planned to avoid mounting the system immediately
adjacent to large power transformers, motors, etc.
POWERING
The 1601S/1601 may be operated from 100-250V AC mains (50-60 Hz, single phase). BE SURE TO VERIFY LINE VOLTAGE
BEFORE CONNECTING THE 1601S/1601 TO THE MAINS.
Please Note. The IEC mains connector is fitted with a retaining clip to prevent the mains lead from accidentally being
pulled out during operation. To ensure that this clip will fit correctly, the lead supplied with the mixer must be used.