Sharp PG-MB60X - Manual (Page 54)

-50
Setting the Video System
The video input system mode is factory preset
to “Auto”; however, a clear picture from the con-
nected audio-visual equipment may not be re-
ceived, depending on the video signal difference.
In that case, switch the video signal.
Menu operation Page 42
Example: “Options1” screen menu for
INPUT 3 (Video) mode
Description of Video Systems
Note
• The video signal can only be set in INPUT 3 or
INPUT 4 mode.
• When “Video System” is set to “Auto”, you may
not receive a clear picture due to signal differ-
ences. Should this occur, switch to video sys-
tem of the source signal.
Description
When connected to PAL video equipment.
When connected to SECAM video equipment.
When reproducing NTSC signals in PAL
video equipment.
When connected to NTSC video equipment.
Selectable items
PAL
SECAM
NTSC4.43
NTSC3.58
Setting On-screen Display
This function allows you to turn the on-screen
messages on or off.
Menu operation Page 42
Example: “Options1” screen menu for
INPUT 1 (RGB) mode
Description of OSD Display Settings
Description
All On-screen Displays are displayed.
• INPUT/VOLUME/AV MUTE/FREEZE/
AUTO SYNC/ENLARGE/ “An invalid
button has been pressed.” are not
displayed.
• “All buttons on Projector are locked.” is
displayed when the STANDBY button is
pressed while the Keylock function is
active.
Selectable items
(ON)
(OFF)
Using the “Options1” Menu