Sharp UX-P115 - Manual (Page 38)

Sending a Fax by Automatic Dialing
36
1
If you are sending a fax, load the
document(s).
•
If desired, press to set the
resolution and/or contrast.
2
Press once. appears in the display, followed by the last
number dialed. Make sure the number that appears is the number you
wish to dial.
3
If you are sending a fax, press . Dialing and transmission
begins.
If you are making a phone call, lift the handset. Dialing begins.
Note: If a fax transmission is unsuccessful and DOCUMENT JAMMED
appears in the display, remove the document as explained on page 71. (This
may occur if the other fax machine doesn’t respond properly when you
attempt to send the document.)
RESOLUTION/
RECEPTION MODE
START/MEMORY
Redial
You can automatically redial the last number dialed. This procedure can to be
used to send a fax or make a phone call.
Automatic redialing
If you use automatic dialing (including Direct Keypad Dialing) to send a fax
and the line is busy, the fax machine will automatically redial the number. The
fax machine will make three redial attempts at an interval of five minutes.
During this time, RECALLING will appear in the display, followed by a two-digit
number assigned to the fax job. You will not be able to dial any other locations
while the message appears.
♦
To stop automatic redialing, press .
♦
Under certain conditions (for example if a person answers the call on a
telephone), automatic redialing may stop before three redialing attempts
are made.
STOP
READY TO SEND