Reset – Samsung CLP 510N User Manual

Page 20

If you connect a remote plug to the REMOTE jack on the
rear of the camera as shown below, you can access the
menu setup mode from a remote place.

You must turn the camera power off when you connect or remove
the remote plug.

NOTE

NOTE

The phase is preset to 225 degrees at the factory. You can re-

adjust it from 0 to 270 degrees.

When the power frequency is 50Hz, you can not use linelock
mode(NTSC Models).
When the power frequency is 60Hz, you can not use the linelock
mode(PAL Models).
’Sync.’ mode is fixed to ‘INT’ in DC12V input power.

NOTE

Notes

This function resets the camera to the default settings pre-
set at the factory.

All modes are initialized and return to the default status.

Reset

Tx (Transmit Data)

GND

Rx (Receive Data)

MD (Motion Detection Signal)

Setup

Camera ID

OFF

Backlight OFF

Motion Detect.

OFF

Lens DC
Shutter ESC
Gain AGC
White Balance

ATW

Color Auto1
Sync. INT
Reset
End

Line Lock

Phase

225

Press SET to Return

COLOR CCD CAMERA

2.5

0.5sec

+4.0V~+5.0V

1. RS-232C Communication Setting.

Mode : Serial
Bit/sec : 9600bps
Port : Com1
Parity : None

2. Setup menu Command.

Setup menu

Command

Byte

Set

A0, A0, 01, 00, 00, AF

A0, A0, 02, 00, 00, AF

Down

A0, A0, 03, 00, 00, AF

Left

A0, A0, 04, 00, 00, AF

Right

A0, A0, 05, 00, 00, AF

3. Motion Detection Output Signal Level.

There is motion

There is no motion