Assembly instructions – Stamina Products 55-1537C User Manual

Page 9

STEP 7:

Attach the

FOOTREST(11)

onto the

HEIGHT ADJUSTMENT BEAM(10)

with the adjustment

holes facing down. Secure the

FOOTREST(11)

in place with the

ADJUSTMENT KNOB(12).

NOTE:

ASSEMBLY INSTRUCTIONS

The four adjustment holes in the

FOOTREST(11)

allow the

FOOTREST(11)

to be attached in

four different positions. Start with one of the center positions and adjust if necessary. Use the outer
position if users are taller than average. Use the inner position if users are shorter than average.

STEP 8

Insert the

HEEL HOLDER TUBE(13)

through the hole on the

HEIGHT ADJUSTMENT BEAM(10)

and secure with

BOLT(M6 x 47mm)(60), WASHERS(M6 x ø16 x 1.5mm Thick)(68),

and

NYLOCK

NUT(M6)(66).

Place a

HEEL HOLDER BRACKET(14)

onto a

HEEL HOLDER(15),

then slide them

onto the

HEEL HOLDER TUBE(13)

together. Repeat on other side.

STEP 9

Insert the

OUTER PAD TUBE(17)

through the hole on the

HEIGHT ADJUSTMENT BEAM(10).

Insert

the

INNER PAD TUBE(16)

into the

OUTER PAD TUBE(17).

Align the holes on the

INNER PAD

TUBE(16),

OUTER PAD TUBE(17)

, and

HEIGHT ADJUSTMENT BEAM(10),

then bolt them together

with

BOLT(M6 x 35mm)(59)

and

ARC WASHER(M6)(71).

WARNING:

The

PAD TUBES(16, 17)

must be assembled with the ends pointed downward as shown.

The ends must be pointed downward to properly secure the users feet in place during inversion.
Improper assembly will allow the user's feet to come loose and the user will fall from the

Elite

Inversion System.