Operational instructions general precautions, Height adjustment – Stamina Products 55-1537C User Manual

Page 11

OPERATIONAL INSTRUCTIONS

GENERAL PRECAUTIONS

Use the lowest holes in the

PIVOT ARMS(

)

until you become familiar with the

Elite Inversion

System

Do not use the

Elite Inversion System

alone. Always have a helper available in case assistance is

needed in recovering from the decline position.
Make sure that the

FOAM PADS(18)

and

HEEL HOLDERS(15)

are holding your feet securely.

Make sure that the

HEIGHT ADJUSTMENT BEAM(10)

is properly set for your height.

Make sure that the

HEIGHT ADJUSTMENT BEAM(10)

is held securely by both the

SPRING PIN(35)

and the

LOCKING KNOB(36).

Make sure that there is enough room for the bed to rotate completely.

3.
4.
5.

HEIGHT ADJUSTMENT

The

Elite Inversion System

is a very sensitive balance device. It responds to very slight changes in

weight distribution. It is very important to make sure that the height adjustment is adjusted properly. Use
the following procedure to set the height adjustment and balance the

Elite Inversion System.

Insert the

PULL PINS(86)

into the second

adjustment holes from the top in the

ANGLE

ADJUSTMENT BARS(85)

to restrict the

movement of the

NYLON BED(37)

to the least

amount of inversion angle. The

PULL PINS(86)

should not be inserted into the lowest adjustment
holes in the

ANGLE ADJUSTMENT

BARS(85),

or the

Elite Inversion System

may

go into the full inversion position while you are
setting the height adjustment.
Loosen the

LOCKING KNOB(36)

under the

MAIN FRAME(

Pull the

SPRING PIN(35)

and use the

SCALE

INDICATION

to set the

HEIGHT ADJUSTMENT

BEAM(10).

Tighten the

LOCKING KNOB(36).

Mount the machine.
Lock your ankles into the

FOAM PADS(18)

and

HEEL HOLDERS(15).

Lie back with your hands at your sides.
Slowly raise your hands to your chest.
If your feet are higher than your head, dismount
and try a taller setting. If you do not rotate to a
position close to level, dismount and try a shorter
setting.

4.
5.
6.

7.
8.
9.

NOTE:

The

Elite Inversion System

should return to the upright position when your hands are below

your waist. If it does not, use a taller setting.