The handrails inversion angle adjustment – Stamina Products 55-1537C User Manual

Page 12

OPERATIONAL INSTRUCTIONS

HEEL HOLDER USE AND ADJUSTMENT

Place your feet on the

FOOTREST(11)

with your ankles between the

HEEL HOLDERS(15)

and

FOAM PADS(18).

The

HEIGHT ADJUSTMENT BEAM(10)

includes a

LEVER(23)

grip and release your feet. Pull the

LEVER(23)

toward you until your

ankles are securely held between the

HEEL HOLDERS(15)

and

FOAM PADS(18).

To release your feet or relax the grip, pull the

LEVER(23)

toward you

slightly and press the button on the end of the lever.

Button

THE HANDRAILS

INVERSION ANGLE ADJUSTMENT

There are 11 adjustment holes in the

ANGLE

ADJUSTMENT BARS(85)

allowing you restrict the

movement of the

NYLON BED(37)

to different angles

by inserting the

PULL PINS(86)

into different

adjustment holes.
The top holes will allow the least amount of inversion
angle. The lowest hole will allow the greatest amount of
inversion angle and the

Elite Inversion System

will

go into the full inversion position.

Use the holes near the top in the

ANGLE

ADJUSTMENT BARS(85)

until you become

familiar with the

Elite Inversion System.

Both

PULL PINS(86)

must be inserted into the same

hole in the

ANGLE ADJUSTMENT BARS(85).

Trying to insert the

PULL PINS(86)

into different

positions could cause damage to the machine, and
injury to the user.

CAUTION:

For added convenience, and safety, a set of

HANDRAILS

has been added to the

Elite Inversion System.

These

HANDRAILS

are located at both sides of the frame. The

HANDRAILS

are to help you return to

the upright position from any degree of inversion. If you wish to return to the upright position, and the bed
is moving too slowly, or not moving at all, simply grab the

HANDRAILS

and pull on them until you return to

the upright position.