Sharp AQUOS LC-19DV28UT - Manual (Page 41)

39
Cautions regarding use in high and low temperature environments
• When the unit is used in a low temperature space (e.g. room, office), the picture may leave trails or appear slightly
delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal.
• Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near a
heater, as this may cause the cabinet to deform and the Liquid Crystal panel to malfunction.
Storage temperature: –4°F to +140°F (–20°C to +60°C)
Appendix
Troubleshooting-DVD
Problem Possible Solution
• Playback doesn’t start. • No disc is inserted. (See page 29.)
• The disc may be dirty. Clean up the disc. (See page 7.)
• The TV/DVD cannot play CD-ROMs, etc. (See page 6.)
• No picture. • TV/DVD selector is not set correctly. (See page 29.)
• No sound. • Check the input selector of the amplifier is set properly.
• The TV/DVD is in the special playback mode. (See page 30.)
• Select the correct Audio Output position on AV amplifier.
• Picture is distorted during fast
reverse/forward playback.
• The picture will be distorted occasionally.
• Stopping playback, search,
slowmotion play, repeat play, or
program play, etc. cannot be
performed.
• Some discs may not do some of the functions.
• No surround sound. • The setup does not match your stereo system.
• The TV/DVD or remote operation
key is not functioning.
• Turn off the TV/DVD and unplug the AC power cord for several minutes, then
replug it.
• Playback does not start when the
title is selected.
• Check the Parental setup. (See page 36.)
• Audio soundtrack and/or subtitle
language is not changed when
you playback a DVD.
• Multilingual language is not recorded on the DVD disc. (See page 31.)
• No subtitle. • Some discs have no subtitles. (See page 31.)
• Subtitles are cleared. Press SUBTITLE. (See page 31.)
• Angle cannot be changed. • Multi-angles are not recorded on the DVD disc. (See page 31.)
• “This operation can’t be performed”
appears on the screen.
• The function is prohibited with the TV/DVD or the disc. (See page 29.)
The password is
NOTE
• As a precautionary measure, make a note of your password above, cut it from this manual, and keep it in a safe place.
.
CLEARING THE PASSWORD
If you forget the password, clear the password using the following procedure.
1 Press and hold both VOL – on the TV/DVD and
press 0 on the remote control simultaneously for
a few seconds until MENU screen appears on the
screen.
2 Now the old password was cleared. You can set
the new password.
54W0131B.indb 39 5/19/10 10:56:05 AM