Sanyo 42LM4RTC User Manual

Page 12

Text mode
Original mode

CALIBRATION

1. Select the

Calib

tab as shown below (Fig 5), click the

'Start Calibration'

box.

Fig 5

2. You will see the following screen (Fig 6); there are three targets to touch in total, like the one

shown below:

Fig 6

3. When each of these targets is displayed, touch and hold

your finger on the centre of the

circular target.

You must touch all three targets in turn

4. The red circle in the target slowly moves towards the centre of the target.
5. Remove your finger only when the next target appears and touch that one.

If the touch calibration is not correct after this procedure, please run the process

again and adjust your finger position on the targets to compensate for the misalignment.

This manual is related to the following products:

42LM4WPTC