Scag Power Equipment V-RIDE SVR52V-26FX - Manual (Page 37)

33
R
Section 7
B. CHANGING ENGINE CRANkCASE OIL
After the first 20 hours of operation, change the engine
crankcase oil and replace the oil filter. Thereafter,
change the engine crankcase oil after every 100 hours of
operation or monthly, whichever occurs first. Refer to the
Engine Operator’s Manual furnished with this mower for
instructions.
ENGINE OIL
FILLER & DIPSTICK
ENGINE OIL
DRAIN
ENGINE OIL
FILTER
Drain Plug, Dipstick and Oil Filter Figure 7-4.
Location
C. CHANGING ENGINE OIL FILTER
After the first 20 hours of operation, replace the engine oil
filter. Thereafter, replace the oil filter after every 200 hours
of operation or every month, whichever occurs first. Refer
to Engine Operator’s Manual for instructions.
DANGER
To avoid injury from burns, allow the mower to
cool before changing the oil and removing the
filter.
HYDRAULIC OIL
FILTER
DRAIN PLUG
Hydraulic Oil Filter Figure 7-3.
C. CHANGING HYDRAULIC OIL FILTER
ELEMENT
The hydraulic oil filter should be changed after every 500
hours of operation or annually, whichever occurs first.
Remove the oil filter element. See Figure 7-3. 1.
Properly discard the oil filter element. Fill the new
filter with clean oil and install the filter. Hand tighten
only.
Run the engine at idle speed with the speed control 2.
lever in neutral for five minutes.
Check the oil level in the hydraulic tank. Hydraulic 3.
oil must be at the full tab below the filler neck. If
necessary, add SAE 20w50 motor oil.
ENGINE OIL 7.4
A. CHECkING ENGINE CRANkCASE OIL LEvEL
The engine oil level should be checked after every 8 hours
of operation or daily as instructed in the Engine Operator’s
Manual furnished with this mower.