SMSC USB2601 - Manual (Page 25)

4th Generation USB 2.0 Flash Media Controller with Integrated Card Power FETs & HS Hub
Datasheet
SMSC USB2601/USB2602 25 Revision 1.6 (06-20-08)
DATASHEET
Note 7.4 Output leakage is measured with the current pins in high impedance.
Note 7.5 See Appendix A for USB DC electrical characteristics.
Note 7.6 The Maximum power dissipation parameters of the package should not be exceeded
Note 7.7 The assignment of each Integrated Card Power FET to a designated Card Connector is
controlled by both firmware and the specific board implementation. Firmware will default to
the settings listed in
Table 9.1, “GPIO Usage (ROM Rev -01),” on page 29
Supply Current
Configured
(High-Speed Host)
3 Ext Ports @HS
Card Reader Active
302 mA
Total from all
supplies
Supply Current
Configured
(High-Speed Host)
1 Ext Port @HS
Card Reader Active
242 mA
Total from all
supplies
Supply Current
Configured
(Full-Speed Host)
1 Ext Port @ FS/LS
Card Reader Active
200 mA
Total from all
supplies
Supply Current
Suspend I
CSBY
298
μA
Total from all
supplies.
Supply Current
Reset I
RST
91
μA
Total from all
supplies.
PARAMETER SYMBOL MIN TYP MAX UNITS COMMENTS