SATO CL612e - Manual (Page 5)

CL ‘e’ Series Quick Guide
Pg 14
CL ‘e’ Series Specifications
The following is a general list of the CL ‘e’ series specifications. For a complete
listing, please refer to the Operator & Technical Reference, Section 1.
SPECIFICATION CL408e CL412e CL608e CL612e
PRINT
Method
Thermal Transfer or Direct Thermal
Speed (User Selectable)
2 – 6 ips
50 – 150 mm/s
4 – 8 ips
100 – 200 mm/s
Processor 32-Bit RISC, 133MHz
Resolution
203dpi
8 dpmm
305 dpi
12 dpmm
203dpi
8 dpmm
305 dpi
12 dpmm
Maximum Print Length
49.2”
1249mm
32.8”
833mm
49.2”
1249mm
32.8”
833mm
Maximum Print Width
4.1”
104mm
6.0”
152mm
6.5”
164mm
MEDIA
Width
0.87” – 5.1”
22mm – 131mm
1.96” – 7”
50mm – 178mm
Minimum Length 0.24” (6mm) 0.78” (20mm)
Roll OD (Maximum) 8.6” (218mm), Wound Face-In
Label Sensing
Transmissive See-Thru, Reflective I-Mark,
Continuous Forms
RIBBON
Length
1475 ft (450M) 1345 ft (410M)
Maximum Width 4.4” (111mm) 6.75” (172mm)
PRINT-OUTS
Text Fonts
12 Proportional & Mono-Spaced OCR-A & OCR-B
10 Scaleable Vector Fonts
Graphics Sato Hex/Binary, .BMP or .PCX
Bar Codes 19 including Four (4) 2-D Bar Codes
Rotation Text & Bar Codes can be rotated 90 o , 180 o & 270 o
PHYSICAL
Dimension
W10.7” x D16.9” x H12.6”
271mm x 429mm x 321mm
W13.8” x D16.9” x H11.7”
352mm x 429mm x 298mm
Weight 28.7 lbs (13 Kg) 41.9 lbs (19 Kg)
POWER REQUIREMENTS
Voltage 110V (± 10%); 220V (± 10%); 50/60Hz (±1%)
Power Consumption 50W Idle; 130W Operating 50W Idle; 210W Operating
ENVIRONMENTAL
Operating 5 – 40 o C; 15 – 85% RH, Non Condensing
Storage -20 – 40 o C; Max 90% RH, Non Condensing
CL ‘e’ Series Quick Guide
Pg 3
Controls & Indicators
Operator Panel
LED Indicators
Status :
Dark when Off Line
Green when printer is On Line
Red when an error condition exists
Flashing green when printer is imaging data
LCD Display :
Illuminated when power is applied
Adjustments (controls behind front panel)
Print :
Adjusts print darkness
Offset:
Adjusts amount of back/forward feed for dispense /
cut / tear-off position (+/- 3.75mm)
Pitch : Adjusts home position of the label +/- 3.75mm. Affects stop
position of label, print position and dispense / cut position.
DSW2-3 :
Sets printer configuration