Sanus Systems VISIONMOUNTTM WALL MOUNT VMAA26 - Manual (Page 3)

Step 1: Mounting Monitor Brackets to a Televisions with a flat back
NOTE: For TVs with a curved back or any other obstruction See Step 2. After completing this step, proceed to Step 3.
Determine the diameter of the Bolt ( P,Q,R,S) your TV requires by hand threading them into the threaded insert on the back of the
TV. If you encounter any resistance stop immediately. Once you have determined the correct diameter, refer to the appropriate
Diagram below. Thread the Bolt through the appropriate Lock Washer ( X,Y,Z,AA), a Washer (DD,EE), the Monitor Bracket (E) and
finally into the TV. Make sure the Monitor Brackets are vertically centered and level with each other. Repeat this process until each
Monitor Bracket is secured to the TV with two bolts.
DD
Q
Y
E
EE
S
AA
E
DD
P
X
E
EE
R
Z
E
M4 Diameter Bolt
M8 Diameter Bolt
M5 Diameter Bolt
M6 Diameter Bolt
Diagram 1