beautypg.com

Sanus Systems VMF User Manual

Assembly instructions for model: vmf

background image

Assembly Instructions for Model: VMF

Thank you for choosing Sanus Systems wall mount furniture. This product is designed to mount VESA 75/100

LCD televisions up to 50 pounds onto a vertical wall. It allows you to effortlessly tilt your new television up to

15° up or down without the use of tools. Check carefully to make sure there are no missing or defective parts.

Never use defective parts. Improper installation may cause damage or serious injury. If you do not understand

these directions, or have any doubts about the safety of the installation, please call a qualified contractor or contact

Sanus at 800.359.5520 or www.sanus.com. We can quickly assist you with installation questions and missing

or damaged parts. Replacement parts for Sanus products purchased through authorized dealers will be shipped

directly to you.

Note: The hardware provided is for wood stud, concrete, brick and concrete block walls.

Required Tools: Drill with 3/16” bit, 1/2” masonry bit, Phillips screw driver

Supplied Parts:

(1) Wall Plate - a

(1) TV Mount Plate - b

(2) Glide - c

(1) Carriage Bolt and Washer - d, e

(1) Knob - f

(2) Lag Bolt - g (4) M4 Bolt - h (1) Allen Key - i

(2) Anchor - j

Mounting the Wall Plate: Wood Stud Installation - Use a high quality stud sensor to locate a stud. It is a

good idea to verify where the stud is located with an awl or thin nail. Use the Wall Plate as a template to mark the

two hole locations on the wall. Make sure these holes are aligned vertically and centered over the stud. Pre-drill

the two holes using a 3/16” drill bit. Tighten the Lag Bolts until they protrude 1/4 inch from the wall. You will

firmly tighten the Lag Bolts during final assembly. See next page for concrete installation.

Diagram 1a

a

stud

g

g

drywall cut away to show stud location