beautypg.com

SoundCraft Spirit Live 3-2 User Manual

Page 28

background image

Page 26

6. Using the M3 screw, washer and nut provided, secure one end of the

earth lead supplied to the screw hole on the left hand side of the
Expander front panel, underneath the arm rest as shown. Ensure that
any paint overspray is removed from the inside of the panel to provide a

good electrical contact with the panel.

7. Using the M5 screws, washers and nuts supplied, bolt the Expander

chassis to the Console chassis as shown.

N.B. Ensure correct orientation and alignment.

8. Re-assemble the Expander top panel and base, gently sliding the units

together as the panel is lowered and threading the Expander bus loom
and earthing lead through the aperture into the console base.

9. The Expander earthing lead must now be joined to the existing earthing

point on the power connector on the main console top panel, which

should be placed knobs down with the rear of the panel next to the rear
of the chassis. Remove the securing nut and washer and reassemble
with the expander earthing lead connected in contact with the existing

earthing lead as shown opposite. Ensure that the nut is tightened

securely.

10. Rotate the main console top panel backwards and reassemble to the

base, taking care not to strain the earthing lead and connecting the bus
loom from the Expander onto the track-side pins of the bus connector

on the Console Master PCB as shown. Carefully adjust the position of
the bus loom as the panel is lowered to ensure that the slack in the
cable folds on the right-hand side of the Master PCB and does not

become trapped between the boards and the base panel.

11. To ensure good mechanical fit, some realignment can be carried out as

the top and base panel screws are tightened.

N.B. Taking care with paintwork, use the correct tools, keep screws safely

and the expansion of your SPIRIT LIVE 3

2

should take no longer than 15

minutes.

Earthing
Screw
Location

Motherloom

Earth Lead

(from Power Connector)

Ground lead

from power

connector

M3 Nut

and

washer

Power

Connector

Ground lead

from expander

(RV2280)

BASE

USERMAN.QXD 13/06/97 13:09 Page 26