SMC Networks SMC7500A/VCP - Manual (Page 23)

P
OWERING
O
N
11
When inserting an RJ-45 plug, be sure the tab on the plug clicks into
position to ensure that it is properly seated.
Caution: Do not plug a phone jack connector into any RJ-45 port. Use
only twisted-pair cables with RJ-45 connectors that conform to
FCC standards.
Notes: 1. When connecting to a hub or switch, use crossover cabling.
(Refer to “Port And Cable Assignments” on page 15 for a
description of crossover cable).
2. Make sure the twisted-pair cable connected to the CPE LAN
port does not exceed 100 meters (328 feet).
Powering On
Plug the power adapter cord into the DC 12V power socket on the side of
the CPE, then plug the power adapter directly into a power outlet. Check
the LED marked POWER on the front panel to be sure it is on.
Configuring the TCP/IP Protocols
To connect the TigerAccess Extended Ethernet CPE to a computer
through its Ethernet port, the computer must have an Ethernet network
adapter card installed, and be configured for the TCP/IP protocol. Many
service providers will configure TCP/IP for client computers
automatically using a networking technology known as Dynamic Host
Configuration Protocol, or DHCP. Other service providers may specify an
IP configuration (known as a static IP address), which must be entered
manually.
Carry out the following steps to check that the computer’s Ethernet port is
correctly configured for DHCP.