SUPER MICRO Computer X8STE - Manual (Page 82)

4-16
X8ST3-F/X8STE User’s Manual
32Bit Data Transfer
Select Enable to enable the function of 32-bit IDE data transfer. The options are
Enabled and Disabled.
 PCI/PnP Configuration
This feature allows the user to set the PCI/PnP configurations for the following
items:
Clear NVRAM
This feature clears the NVRAM during system boot. The options are
No and
Yes.
Plug & Play OS
Selecting Yes allows the OS to configure Plug & Play devices. (This is not required
for system boot if your system has an OS that supports Plug & Play.) Select
No to
allow the AMI BIOS to configure all devices in the system.
PCI Latency Timer
This feature sets the latency Timer of each PCI device installed on a PCI bus. Select
64 to set the PCI latency to 64 PCI clock cycles. The options are 32,
64, 96, 128,
160, 192, 224 and 248.
PCI IDE Bus Master
When enabled, the BIOS uses PCI bus mastering for reading/writing to IDE drives.
The options are Disabled and
Enabled.
PCI Slot 1 ~ PCI Slot 6
Use this setting to disable any of the PCI slots. The options are Disabled and
Enabled.
Load Onboard LAN1 Option ROM, Load Onboard LAN2 Option ROM
This feature is to enable LAN OPROM for PXE. This is to boot computers using a
network interface. The options are
Disabled and Enabled.
Load SAS Option ROM (X8ST3-F Only)
This feature is to load the Serial Attached SCSI (SAS) option ROM, if available.
The options are Disabled and
Enabled.