beautypg.com

Using the md display – Sony MDS-JE780 User Manual

Page 22

background image

22

GB

Using the MD display

Press LEVEL/DISPLAY/CHAR (or DISPLAY)
repeatedly.

The display changes cyclically as follows:

Note

Note that, depending on the status of the deck, the
display may not conform with the cycle shown below.

During playing

Track name, track number and elapsed time of
the current track

t Track name, track number

and remaining time of the current track

t

Track name and remaining time of all recorded
tracks

1)

t Disc name and track name

2)

t

Level of the output signal

t Pitch, track

number and elapsed time of the current track

1)

When the Group function is on, the remaining
time of all tracks within the group is displayed.

2)

“No Name” appears when the disc or track has no
name. When the Group function is on, the group
name and track name are displayed.

Turning off indications in the display

You can use Setup Menu to turn off the display during
playing. The display turns back on if you press x or
X.

1 While the deck is stopped or playing, press

MENU/NO.

2 Turn AMS (or press

./>

repeatedly)

until “Setup?” appears, then press AMS or
YES.

3 Turn AMS (or press

./>

repeatedly)

until “Display On” (factory setting) appears,
then press AMS or YES.

4 Turn AMS (or press

./>

repeatedly)

to select “Display Off”, then press AMS or
YES.

5 Press MENU/NO.

To turn on the display, select “Display On” in step 4
above.

Tip

To check the track name during playing (only when
the track name is recorded)

,

press SCROLL on the

remote. The track name appears and scrolls. While the
track name is scrolling, press the button again to pause
scrolling, and again to continue scrolling.

In stop mode

Disc name

1)

, total number of tracks and total

recorded time

t Disc name

1)

, total number of

tracks and remaining recordable time

2)

on the

MD (recordable MDs only)

t Level of the

input signal (setting value of the recording
level)

t Pitch, total number of tracks and total

recorded time

1)

“No Name” appears when the disc or track has no
name. When the Group function is on, the disc
name and the total number of groups (when no
group is selected) or the group name and the total
number of tracks and recorded time within the
group (when a group is selected) are displayed.

2)

Time shown in the display differs depending on
the setting of REC MODE.