SVAT Electronics CVQ1000 - Manual (Page 10)

CVQ1000 7
SVAT ELECTRONICS
now you can see
D. CAMERA SETUP:
- Camera 1: Press to switch
desired camera.
- Title: Press to move the cursor,
and press to adjust character.
- Press to adjust Brightness,
Contrast, Saturation, Hue and Sharpness.
- To exit, press MENU button again.
E. MOTION SETUP:
- Camera 1: Choose desired camera.
- Detection Time: To enable / disable
detection of the cameras.
- Masking area: To disable an area
you wish not to detect.
- To exit, press MENU button again.
F. EVENT SETUP & EVENT REPORT:
- Loss: If any camera loses its signal, the
time of signal loss will be recorded in
Event report.
- Motion: If motion is detected in front of
camera, the time of motion detection will
be recorded in Event report.
- Buzzer hold time: Enables or disables
buzzer function and can be set from
OFF to 99 sec..
- Report hold time: Enables or disables
the report function and can be set from
OFF to 99 sec.
- 6 pages of "EVENT REPORT" are
available in this system.
- Report can be deleted by choosing
"YES" on LIST CLEAR section.
- To exit, press MENU button again.
- Press any button except "OK" on the
switch box to clear the alarm noise.
- Alarm / Alarm Polarity: To enable the
Power-On alarm, all 4 alarm checks
should be ticked together with Alarm
Polarity set to "High".