Inserting the network card – SMC Networks TigerCard 1000 User Manual

Page 15

1-6

NSTALLING

THE

ETWORK

ARD

Inserting the Network Card

WARNINGS:
• Network cards are sensitive to static electricity. To protect the

card, avoid touching its electrical components and always touch
the metal chassis of your computer before handling the card.

• Backup your SuperDisk driver diskette and use the copy as the

working diskette to protect the original from accidental
damage.

1. Switch off the computer, unplug the power cord, and remove

the computer’s cover.

2. Select an available 32-bit or 64-bit bus-mastering PCI slot and

remove the cover bracket.

•

Use a 64-bit PCI slot if your PC supports this standard.

•

If using a 32-bit PCI slot, the end of the card’s edge

connector will be exposed. Be careful that it does not touch
any conducting parts on the PC motherboard.

Note: Some PC motherboard designs may not provide

adequate space behind all 32-bit PCI slots to properly
install the network card.

3. Install the network card into the slot so that it is firmly seated.

Then, screw the card’s bracket securely into the PC’s chassis.