Woodstock STEELEX ST1000 - Manual (Page 13)

ST1000 14" Bandsaw -11-
Figure 10. Installed cap screws.
Figure 11. Attaching the switch.
Components and Hardware Needed: Qty
Motor ........................................................................................ 1
Switch ....................................................................................... 1
Cap Screws M8-1.25 x 25 ................................................... 2
Flat Washers 8mm ................................................................ 2
Lock Washers 8mm .............................................................. 2
Phillips Head Screws M5-.8 x 12 ..................................... 2
Phillips Head Screws M5-.8 x 15 ..................................... 2
External Tooth Lock Washers 5mm ................................ 2
Phillips Head Screw M5-.8 x 6 .......................................... 1
Star Washer 5mm ................................................................. 1
Metal Cord Clamp ................................................................ 1
Plastic Cord Clamp ............................................................... 1
To install the motor and switch:
1. Place the motor into the motor mounting area
on the bottom of the main body (Figure 9).
Motor & Switch
Figure 9. Placing motor on the body.
Front Cord
Clamp
Plastic Cord
Clamp Location
2. Loosely thread the cap screws, flat washers and
lock washers into the motor (Figure 10).
3. Place the V-belt on the pulley, move the motor
to the left with moderate pressure, and tighten
the cap screws.
4. Push the belt with moderate pressure. If the belt
deflects more than 3 /
4
", repeat Step 3.
5. Ground the switch with the M5-.8 x 6 Phillips
head screw and 5mm star washer, then attach
the switch to the body with the M5-.8 x 15
Phillips head screws and 5mm eternal tooth lock
washer (Figure
11).
6. Secure the cords on the front of the bandsaw
body with the metal cord clamp and an M5-.8 x
12 Phillips head screw.
7. Secure the cord on the rear of the bandsaw
body with the plastic cord clamp and an M5-.8 x
12 Phillips head screw (Figure 9).