Sharp CD SW340 - Manual (Page 32)

03/12/17 CD-SW340 02-43.fm
32
CD-SW340
Advanced Features
Timer and sleep operation (Remote control only) (continued)
Timer playback or timer recording
Before setting timer:
1 Check that the clock is set to the correct time (refer to page 16).
If it is not set, you cannot use the timer function.
2 For timer playback:
For timer recording:
Load a cassette or discs to be played.
Load a cassette for recording in the
cassette compartment.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CLOCK/TIMER button.
3 Within 10 seconds, press the or button to select
“ONCE” or “DAILY”, and press the MEMORY button.
Set the clock to the correct time if “ONCE” or “DAILY” does not
appear.
4 Within 10 seconds, press the or button to
select “ONCE SET” or “DAILY SET”, and press the
MEMORY button.
5 Press the or button to select “PLAY” or
“REC”, and press the MEMORY button.
The illustrations show the daily timer setting.
6 Press the or button to adjust the hour and
then press the MEMORY button.
The illustrations show the timer playback setting in the daily
timer mode.
7 Press the or button to adjust the minutes and
then press the MEMORY button.
8 Set the time to finish as in steps 6 and 7 above.
9 Switch input with the or button, and then
press the MEMORY button.
To select the timer playback source: CD, TUNER, TAPE 1 or
TAPE 2.
To select the timer recording source: TUNER.
When you select the tuner, select a station by pressing the
or button, and then press the MEMORY
button.
If a station has not been programmed, “NO PRESET” will
be displayed and timer setting will be canceled.
White Red